ABB ACS880 - Page 242

Def / Type
FbEq 16b / 32b
DescriptionName / Range /
Selection
No.
10 = 1 s / 100 = 1 sDeactivation delay for DIO1.0.00 ... 3000.00 s
Input / uint16(Visible when 14.1 Module 1 type = FIO-11)
Selects whether DIO2 of the extension module is used
as a digital input or output.
DIO2 function14.14
0DIO2 is used as a digital output.Output
1DIO2 is used as a digital input.Input
Input / uint16(Visible when 14.1 Module 1 type = FIO-01)
Selects whether DIO2 of the extension module is used
as a digital input or output.
DIO2 function14.14
0DIO2 is used as a digital output.Output
1DIO2 is used as a digital input.Input
Not energized /
uint32
(Visible when 14.1 Module 1 type = FIO-11)
Selects a drive signal to be connected to digital
input/output DIO2 when parameter 14.14 DIO2 function
is set to Output.
For the available selections, see parameter 14.11 DIO1
output source.
DIO2 output source14.16
Not energized /
uint32
(Visible when 14.1 Module 1 type = FIO-01)
Selects a drive signal to be connected to digital
input/output DIO2 when parameter 14.14 DIO2 function
is set to Output.
For the available selections, see parameter 14.11 DIO1
output source.
DIO2 output source14.16
0.00 s / real32(Visible when 14.1 Module 1 type = FDIO-01)
Defines the activation delay for digital input DI2. See
parameter 14.12 DI1 ON delay.
DI2 ON delay14.17
10 = 1 s / 100 = 1 sActivation delay for DI2.0.00 ... 3000.00 s
0.00 s / real32(Visible when 14.1 Module 1 type = FIO-11)
Defines the activation delay for digital input/output
DIO2. See parameter 14.12 DIO1 ON delay.
DIO2 ON delay14.17
10 = 1 s / 100 = 1 sActivation delay for DIO2.0.00 ... 3000.00 s
0.00 s / real32(Visible when 14.1 Module 1 type = FIO-01)
Defines the activation delay for digital input/output
DIO2. See parameter 14.12 DIO1 ON delay.
DIO2 ON delay14.17
10 = 1 s / 100 = 1 sActivation delay for DIO2.0.00 ... 3000.00 s
0.00 s / real32(Visible when 14.1 Module 1 type = FDIO-01)
Defines the deactivation delay for digital input DI2. See
parameter 14.12 DI1 ON delay.
DI2 OFF delay14.18
10 = 1 s / 100 = 1 sDeactivation delay for DI2.0.00 ... 3000.00 s
0.00 s / real32(Visible when 14.1 Module 1 type = FIO-11)
Defines the deactivation delay for digital input/output
DIO2.
See parameter 14.12 DIO1 ON delay.
DIO2 OFF delay14.18
10 = 1 s / 100 = 1 sDeactivation delay for DIO2.0.00 ... 3000.00 s
242 Parameters