ABB ACS880 - Page 245

To Next Page

To Previous Page

Def / Type

FbEq 16b / 32b

DescriptionName / Range /

Selection

No.

0Tuning action completed or no action has been

requested.

The parameter automatically reverts to this value after

any tuning action.

No action

1The measured value of AI1 is set as the minimum value

of AI1 into parameter 14.33 AI1 min.

AI1 min tune

2The measured value of AI1 is set as the maximum value

of AI1 into parameter 14.34 AI1 max.

AI1 max tune

3The measured value of AI2 is set as the minimum value

of AI2 into parameter 14.48 AI2 min.

AI2 min tune

4The measured value of AI2 is set as the maximum value

of AI2 into parameter 14.49 AI2 max.

AI2 max tune

5The measured value of AI3 is set as the minimum value

of AI3 into parameter 14.63 AI3 min.

AI3 min tune

6The measured value of AI3 is set as the maximum value

of AI3 into parameter 14.64 AI3 max.

AI3 max tune

Not energized /

uint32

(Visible when 14.1 Module 1 type = FIO-01)

Selects a drive signal to be connected to digital

input/output DIO3 when parameter 14.19 DIO3 function

is set to Output.

For the available selections, see parameter 14.11 DIO1

output source.

DIO3 output source14.21

- / uint16(Visible when 14.1 Module 1 type = FAIO-01)

The true readings of the analog inputs can be

overridden for eg. testing purposes. A forced value

parameter is provided for each analog input, and its

value is applied whenever the corresponding bit in this

parameter is 1.

AI force selection14.22

1 = Force mode: Force AI1 to value of parameter 14.28

AI1 force data.

AI1b0

1 = Force mode: Force AI2 to value of parameter 14.43

AI2 force data.

AI2b1

Reservedb2…15

1 = 10000h…FFFFh

0.00 s / real32(Visible when 14.1 Module 1 type = FDIO-01)

Defines the activation delay for digital input DI3. See

parameter 14.12 DI1 ON delay.

DI3 ON delay14.22

10 = 1 s / 100 = 1 sActivation delay for DI3.0.00 ... 3000.00 s

- / uint16(Visible when 14.1 Module 1 type = FIO-11)