ABB ACS880 - Page 258

Def / Type
FbEq 16b / 32b
DescriptionName / Range /
Selection
No.
- / uint16(Visible when 14.1 Module 1 type = FIO-11)
The value of the analog output can be overridden for
eg. testing purposes. A forced value parameter (14.78
AO1 force data) is provided for the analog output, and
its value is applied whenever the corresponding bit in
this parameter is 1.
AO force selection14.71
1 = Force mode: Force AO1 to value of parameter 14.78
AO1 force data.
AO1b0
Reservedb1…15
1 = 10000h…FFFFh
- / real32(Visible when 14.1 Module 1 type = FAIO-01)
Displays the value of AO1 in mA.
This parameter is read-only.
AO1 actual value14.76
1000 = 1 mA / 1000 =
1 mA
Value of AO1.0.000 ... 22.000 mA
Zero / uint32(Visible when 14.1 Module 1 type = FAIO-01)
Selects a signal to be connected to analog output AO1.
Alternatively, sets the output to excitation mode to
feed a constant current to a temperature sensor.
AO1 source14.77
0NoneZero
11.1 Motor speed used (page 174).Motor speed used
31.6 Output frequency (page 174).Output frequency
41.7 Motor current (page 174).Motor current
61.10 Motor torque (page 174).Motor torque
71.11 DC voltage (page 175).DC voltage
81.14 Output power (page 175).Power inu out
1023.1 Speed ref ramp input (page 311).Speed ref ramp in
1123.2 Speed ref ramp output (page 311).Speed ref ramp out
1224.1 Used speed reference (page 318).Speed ref used
1326.2 Torque reference used (page 338).Torq ref used
1428.2 Frequency ref ramp output (page 347).Freq ref used
1640.1 Process PID output actual (page 420).Process PID out
1740.2 Process PID feedback actual (page 420).Process PID fbk
1840.3 Process PID setpoint actual (page 420).Process PID act
1940.4 Process PID deviation actual (page 420).Process PID dev
See Terms and abbreviations (page 169).Other [value]
20The output is used to feed an excitation current to 1…3
Pt100 sensors. See section Motor thermal
protection (page 128).
Force Pt100
excitation
21The output is used to feed an excitation current to a
KTY84 sensor. See section Motor thermal
protection (page 128).
Force KTY84
excitation
258 Parameters