ABB ACS880 - Page 339

Def / Type
FbEq 16b / 32b
DescriptionName / Range /
Selection
No.
112.12 AI1 scaled value (page 226).AI1 scaled
212.22 AI2 scaled value (page 228).AI2 scaled
43.5 FB A reference 1 (page 179).FB A ref1
53.6 FB A reference 2 (page 179).FB A ref2
83.9 EFB reference 1 (page 179).EFB ref1
93.10 EFB reference 2 (page 179).EFB ref2
103.11 DDCS controller ref 1 (page 179).DDCS ctrl ref1
113.12 DDCS controller ref 2 (page 179).DDCS ctrl ref2
123.13 M/F or D2D ref1 (page 180).M/F reference 1
133.14 M/F or D2D ref2 (page 180).M/F reference 2
15Motor
potentiometer
1640.1 Process PID output actual (output of the process
PID controller).
PID
18Control panel reference, with initial value from last-used
panel reference. See section Using the control panel as
an external control source (page 41).
Control panel (ref
saved)
19Control panel reference, with initial value from previous
source or actual value. See section Using the control
panel as an external control source (page 41).
Control panel (ref
copied)
See Terms and abbreviations (page 169).Other [value]
Zero / uint32Selects torque reference source 2.
For the selections, and a diagram of reference source
selection, see parameter 26.11 Torque ref1 source.
Torque ref2 source26.12
Ref1 / uint16Selects a mathematical function between the reference
sources selected by parameters 26.11 Torque ref1
source and 26.12 Torque ref2 source. See diagram at
26.11 Torque ref1 source.
Torque ref1 function26.13
0Signal selected by 26.11 Torque ref1 source is used as
torque reference 1 as such (no function applied).
Ref1
1The sum of the reference sources is used as torque
reference 1.
Add (ref1 + ref2)
2The subtraction ([26.11 Torque ref1 source] - [26.12
Torque ref2 source]) of the reference sources is used
as torque reference 1.
Sub (ref1 - ref2)
3The multiplication of the reference sources is used as
torque reference 1.
Mul (ref1 x ref2)
4The smaller of the reference sources is used as torque
reference 1.
Min (ref1, ref2)
5The greater of the reference sources is used as torque
reference 1.
Max (ref1, ref2)
Parameters 339