ABB ACS880 - Page 383

Def / Type
FbEq 16b / 32b
DescriptionName / Range /
Selection
No.
4Action is taken whenever the absolute value of the
signal rises above its (absolute) upper limit.
Abs high
5Action is taken whenever the signal falls below its low
limit or rises above its high limit.
Both
6Action is taken whenever the absolute value of the
signal falls below its (absolute) low limit or rises above
its (absolute) high limit.
Abs both
No action / uint16Selects the action the drive takes when the value
monitored by signal supervision 3 exceeds its limits.
Note: This parameter does not affect the status
indicated by 32.1 Supervision status.
Supervision 3 action32.26
0No action taken.No action
1A warning (A8B2 Signal supervision 3) is generated.Warning
2The drive trips on 80B2 Signal supervision 3.Fault
3If running, the drive trips on 80B2 Signal supervision 3.Fault if running
Zero / uint32Selects the signal to be monitored by signal supervision
function 3.
For the available selections, see parameter 32.7
Supervision 1 signal.
Supervision 3 signal32.27
0.000 s / real32Defines a filter time constant for the signal monitored
by signal supervision 3.
Supervision 3 filter
time
32.28
1000 = 1 s / 1000 = 1
s
Signal filter time.0.000 ... 30.000 s
0.00 / real32Defines the lower limit for signal supervision 3.Supervision 3 low32.29
- / -Low limit.-21474830.00 ...
21474830.00
0.00 / real32Defines the upper limit for signal supervision 3.Supervision 3 high32.30
- / -Upper limit.-21474830.00 ...
21474830.00
- / uint16Signal supervision status word. Indicates whether the
values monitored by the signal supervision functions
are within or outside their respective limits.
Note: This word is independent of the drive actions
defined by parameters 32.1, 32.6, 32.16, and 32.25. In
addition, it is also independent of 32.205, 32.215, 32.225,
and 32.235
Supervision status32.200
1 = Signal selected by parameter 32.7 Supervision 1
signal is outside its limits.
Supervision 1 activeb0
1 = Signal selected by parameter 32.17 Supervision 2
signal is outside its limits.
Supervision 2 activeb1
1 = Signal selected by parameter 32.27 Supervision 3
signal is outside its limits.
Supervision 3 activeb2
1 = Signal selected by parameter 32.207 Supervision 4
signal is outside its limits.
Supervision 4 activeb3
Parameters 383