ABB ACS880 - Page 395

Def / Type
FbEq 16b / 32b
DescriptionName / Range /
Selection
No.
1.000 / real32Defines a divisor for value counter 1. The value of the
monitored signal is divided by this value before
integration.
Value counter 1
divider
33.54
- / -Divisor for value counter 1.0.001 ... 2147483.000
Value counter 1
exceeded / uint32
Selects the optional warning message for value counter
1.
Value counter 1 warn
message
33.55
4A88A Value counter 1. The message text can be edited
on the control panel by choosing Menu – Settings – Edit
texts.
Value counter 1
exceeded
10A880 Motor bearing.Maintain motor
bearing
0 / real32Displays the actual present value of value counter 2.
The value of the source selected by parameter 33.63
Value counter 2 source is read at one-second intervals
and added to the counter. A divisor can be applied to
the count (see 33.64 Value counter 2 divider).
When the counter exceeds the limit set by 33.61 Value
counter 2 warn limit, bit 5 of 33.1 Counter status is set
to 1.
The warning specified by 33.65 Value counter 2 warn
message is also given if enabled by 33.62 Value counter
2 function.
The counter can be reset from the Drive Composer PC
tool, or from the control panel by keeping Reset
depressed for over 3 seconds.
Value counter 2
actual
33.60
- / -Actual present value of value counter 2.-2147483008...2147483008
- / real32Sets the limit for value counter 2.
With a positive limit, bit 5 of 33.1 Counter status is set
to 1 (and a warning optionally generated) when the
counter is equal or greater than the limit.
With a negative limit, bit 5 of 33.1 Counter status is set
to 1 (and a warning optionally generated) when the
counter is equal or smaller than the limit.
0 = Counter disabled.
Value counter 2 warn
limit
33.61
- / -Limit for value counter 2.-2147483008...2147483008
- / uint16Configures value counter 2.Value counter 2
function
33.62
0 = Loop: When the limit is reached, the counter is reset.
The counter status (bit 5 of 33.1) switches to 1 for one
second. The warning (if enabled) stays active for at
least 10 seconds.
1 = Saturate: When the limit is reached, the counter
status (bit 5 of 33.1) switches to 1, and remains so until
33.60 is reset. The warning (if enabled) also stays active
until 33.60 is reset.
Counter modeb0
Warning enable
0 = Disable: No warning is given when the limit is
reached
1 = Enable: A warning (see 33.65) is given when the limit
is reached
Warning enableb1
Parameters 395