ABB ACS880 - Page 421

Def / Type
FbEq 16b / 32b
DescriptionName / Range /
Selection
No.
1 = Process PID setpoint frozen.Setpoint frozenb1
1 = Process PID controller output frozen.Output frozenb2
1 = Sleep mode active.PID sleep modeb3
1 = Sleep boost active.Sleep boostb4
1 = Trim function active.Trim modeb5
1 = Tracking function active.Tracking modeb6
1 = PID output is being limited by par. 40.37.Output limit highb7
1 = PID output is being limited by par. 40.36.Output limit lowb8
1 = Deadband active (see par. 40.39)Deadband activeb9
0 = Parameter set 1 in use. 1 = Parameter set 2 in use.PID setb10
Reservedb11
1 = Internal setpoint active (see par. 40.16…40.24)Internal setpoint
active
b12
Reservedb13…15
1 = 10000h…FFFFh
Off / uint16Activates/deactivates process PID control. See also
parameter 40.60 Set 1 PID activation source.
Note: Process PID control is only available in external
control; see section Local control vs. external control.
Set 1 PID operation
mode
40.7
0Process PID control inactive.Off
1Process PID control active.On
2Process PID control is active when the drive is running.On when drive
running
AI1 scaled / uint32Selects the first source of process feedback. See the
control chain diagram on page 758.
Set 1 feedback 1
source
40.8
0None.Not selected
112.12 AI1 scaled value (page 226).AI1 scaled
212.22 AI2 scaled value (page 228).AI2 scaled
311.39 Freq in 1 scaled.Freq in scaled
51.7 Motor current.Motor current
61.14 Output power.Power inu out
71.10 Motor torque (page 174).Motor torque
1040.91 Feedback data storage (page 433).Feedback data
storage
See Terms and abbreviations (page 169).Other [value]
Not selected / uint32Selects the second source of process feedback.
For the selections, see parameter 40.8 Set 1 feedback
1 source.
Set 1 feedback 2
source
40.9
Parameters 421