Def / Type
FbEq 16b / 32b
DescriptionName / Range /
Selection
No.
Energy tariff 1 /
uint32
Selects (or defines a source that selects) which
pre-defined energy tariff is used.
0 = 45.12 Energy tariff 1
1 = 45.13 Energy tariff 2
Tariff selection45.14
00.Energy tariff 1
11.Energy tariff 2
2Digital input DI1 (10.2 DI delayed status, bit 0).DI1
3Digital input DI2 (10.2 DI delayed status, bit 1).DI2
4Digital input DI3 (10.2 DI delayed status, bit 2).DI3
5Digital input DI4 (10.2 DI delayed status, bit 3).DI4
6Digital input DI5 (10.2 DI delayed status, bit 4).DI5
7Digital input DI6 (10.2 DI delayed status, bit 5).DI6
10Digital input/output DIO1 (11.2 DIO delayed status, bit
0).
DIO1
11Digital input/output DIO2 (11.2 DIO delayed status, bit
1).
DIO2
See Terms and abbreviations (page 169).Other [bit]
EUR / uint16Specifies the currency used for the savings calculations.Tariff currency unit45.17
101Euro.EUR
102Dollar.USD
100Local currency. The name of the currency can be edited
by choosing Menu - Settings - Edit texts on the control
panel.
Local currency
0.500 tn_MWh /
uint16
Defines a factor for conversion of saved energy into
CO2 emissions (kg/kWh or tn/MWh).
CO2 conversion
factor
45.18
1 = 1 tn_MWh / 100 =
1 tn_MWh
Factor for conversion of saved energy into CO
2
emissions.
0.000 ... 65.535
tn_MWh
0.0 kW / real32Actual power that the motor absorbs when connected
direct on-line and operating the application. The value
is used for reference when energy savings are
calculated.
Note: The accuracy of the energy savings calculation
is directly dependent on the accuracy of this value. If
nothing is entered here, then the nominal motor power
is used by the calculation, but that may inflate the
energy savings reported as many motors do not absorb
nameplate power.
Comparison power45.19
- / -Motor power. For scaling, see parameter 46.4.0.0 ... 100000.0 kW
Done / uint16Resets the savings counter parameters 45.1…45.9Energy calculations
reset
45.21
0Reset not requested (normal operation), or reset
complete.
Done
Parameters 449