ABB ACS880 - Page 562

Def / Type
FbEq 16b / 32b
DescriptionName / Range /
Selection
No.
- / real32See parameter 85.18 Workzone 1/3 Head 1.Workzone 1/3 Head
3
85.38
- / real32See parameter 85.19 Workzone 2/3 Head 1.Workzone 2/3 Head
3
85.39
- / real32See parameter 85.10 Head at 0 flowrate 1.Head at 0 flowrate 485.40
- / real32See parameter 85.11 Flowrate max 1.Flowrate max 485.41
- / real32See parameter 85.12 Downthrust head 1.Downthrust head 485.42
- / real32See parameter 85.13 Downthrust flowrate 1.Downthrust flowrate
4
85.43
- / real32See parameter 85.14 Upthrust head 1.Upthrust head 485.44
- / real32See parameter 85.15 Upthrust flowrate 1.Upthrust flowrate 485.45
- / real32See parameter 85.16 DNT zone 50% Head 1.DNT zone 50% Head
4
85.46
- / real32See parameter 85.17 UPT zone 50% Head 1.UPT zone 50% Head
4
85.47
- / real32See parameter 85.18 Workzone 1/3 Head 1.Workzone 1/3 Head
4
85.48
- / real32See parameter 85.19 Workzone 2/3 Head 1.Workzone 2/3 Head
4
85.49
- / real32See parameter 85.10 Head at 0 flowrate 1.Head at 0 flowrate 585.50
- / real32See parameter 85.11 Flowrate max 1.Flowrate max 585.51
- / real32See parameter 85.12 Downthrust head 1.Downthrust head 585.52
- / real32See parameter 85.13 Downthrust flowrate 1.Downthrust flowrate
5
85.53
- / real32See parameter 85.14 Upthrust head 1.Upthrust head 585.54
- / real32See parameter 85.15 Upthrust flowrate 1.Upthrust flowrate 585.55
- / real32See parameter 85.16 DNT zone 50% Head 1.DNT zone 50% Head
5
85.56
- / real32See parameter 85.17 UPT zone 50% Head 1.UPT zone 50% Head
5
85.57
- / real32See parameter 85.18 Workzone 1/3 Head 1.Workzone 1/3 Head
5
85.58
- / real32See parameter 85.19 Workzone 2/3 Head 1.Workzone 2/3 Head
5
85.59
Not selected / unit32Defines the source for the curve fine tune enable signal.
When the function is active, the user can adjust the
actual curvature for each of seven segments of the
defined pump curves with parameters 85.61...85.67.
Curve fine tune
enable
85.60
0Curve fine tune enable function is not selected.Not selected
1Curve fine tune enable function is selected.Selected
2Digital input DI1 (10.2 DI delayed status, bit 0).DI1
3Digital input DI2 (10.2 DI delayed status, bit 1).DI2
562 Parameters