ABB Advance Optima magnos206 - Section B Calibration Data

42/24-10 EN Rev. 9 Chapter 8: Gas Analyzer Calibration 8-B-1
Section B Calibration Data
The “Calibration Data” Sub-Menu
Menu
⏐
⏐ __ Calibrate
⏐
⏐ __ Configure
↓ ⏐
⏐ __ Component specific
⏐
⏐ __ Calibration data
↓ ⏐
⏐ __ Manual calibration
⏐ ⏐ __
Test gas concentration
⏐ ⏐ __
Calibration method
⏐
⏐ __ Automatic calibration
⏐ ⏐ __
Enable
⏐ ⏐ __
Cycle time
⏐ ⏐ __
Next cal. date
⏐ ⏐ __
Next cal. time
⏐ ⏐ __
Operating mode
⏐ ⏐ __
Test gas concentration
⏐ ⏐ __
Components for calibration
⏐ ⏐ __
Cancel management
⏐ ⏐ __
Advanced settings
⏐ ⏐
Pump
⏐ ⏐
Purge time: meas->cal gas
⏐ ⏐
Purge time: zero<->span gas
⏐ ⏐
Purge time: cal->meas gas
⏐ ⏐
Hold time for chart rec.
⏐ ⏐
Pressure switch activated for
⏐ ⏐
Single zero cal.
⏐ ⏐
Single span cal.
⏐ ⏐
Zero & span cal.
⏐ ⏐
Calibration method
⏐
⏐ __ Ext. controlled calibration
⏐ ⏐ __
Calibration method
⏐ ⏐ __
Calculation method
⏐ ⏐ __
Test gas concentration
⏐ ⏐ __
Components for calibration
⏐
⏐ __ Output current response