7-40 Chapter 7: Configuration SHB_U14
Flow detector
General
An internal flow sensor can be used to measure throughput. In this case, flow
detector 1 is configured.
Detector
configuration
Detector
Detector type: Flow Detector 1
Active Component Flow l/h
Correction functions None
Update mode Applies to detector raw measurement value; default:
Cyclical
Cycle Time Default: 5000ms
Delta Offset: Not applicable to auxiliary detectors
Delta amplification Not applicable to auxiliary detectors
Over Offset Not applicable to auxiliary detectors
Over amplification Not applicable to auxiliary detectors
Classification Variables or variables display
"Variables display" invokes a display on the AO screen
Continued on next page
To Next Page
Loading...
