SHB_U14 Chapter 6: Component Interchange 6-1
Chapter 6: Component Interchange
Overview
Introduction
This chapter contains the steps and procedures to be followed when interchanging
components.
In order to remove and install components safely and correctly, read and follow all
the instructions and warnings in this chapter.
Caution!
The tasks described in this chapter require special training and under certain
conditions involve working on the analyzer while it is open and powered up.
For this reason, these tasks should only be carried out by specially trained
and qualified persons.
Chapter contents
You will find the following information in this chapter:
Subject See page
Summary 6-2
Remove/install Uras 14 analyzer module 6-3
Change emitter insert 6-5
Change modulator 6-6
Change sample cell 6-7
Change calibration cell and calibration unit 6-9
Change infrared detector 6-10
Change IR module and Sensor-CPU circuit boards 6-11
Change thermal link 6-12
To Next Page
Loading...
