AWT420 | UNIVERSAL 4-WIRE, DUAL-INPUT TRANSMITTER | CI/AWT420-EN REV. B
17
Referring to Figure 14:
7 Fit alignment tab I into gland plate slot K (on plastic case
variant) or in the casting slot (on metal case variant).
8 Insert EZLink connector body L fully into cable entry and
align the connector body using the flats on the alignment
washer (see Figure 13).
9 Screw back nut J onto connector body and tighten using
a spanner.
Figure 14 Securing the EZLink connector cable assembly
Referring to Figure 15:
10 Place EZLink cable plug M into EZLink connector block
cradle A.
11 Plug connector block cradle A into EZLink module N.
Figure 15 Connecting the EZLink cable assembly
12 If a second EZLink module is required, repeat all steps.
13 Close and lock transmitter door B.
I
J
K
L
To Next Page
Loading...
