9.7 Special tools
General
All service instructions contain lists of tools required to perform the specified
activity. The required tools are a sum of standard tools, defined in the section
Standard toolkit on page 1087, and of special tools, listed directly in the instructions
and also gathered in this section.
Special tools
Note
If the replacing procedure is not listed in the table below, only standard tools are
needed for the procedure.
Continues on next page
1088 Product manual - CRB 15000
3HAC077389-001 Revision: L
© Copyright 2021 - 2023 ABB. All rights reserved.
9 Reference information
9.7 Special tools
To Next Page
Loading...
