ABB CRB 15000 - Page 197

NoteAction
See Manually releasing the brakes
on page 69.
Test the brake release functionality on each axis,
by using the brake release tool.
1
For OmniCore, all event logs from
the software can be seen on the
FlexPendant, or in Technical refer-
ence manual - Event logs for Robot-
Ware 7.
If the holding brake does not release, check fol-
lowing:
• Check for event log messages on the
FlexPendant.
• Look for damage to the magnet.
Replace the tool if damaged.
• See troubleshooting section Brake release
tool does not work on page 1063.
2
Product manual - CRB 15000 197
3HAC077389-001 Revision: L
© Copyright 2021 - 2023 ABB. All rights reserved.
4 Maintenance
4.5.1 Testing the brake release functionality
Continued