NoteAction
Hex socket head cap screw: M5x30
12.9 Lafre 2C2B/FC6.9 (16 pcs)
Secure the swing with the attachment screws.
Pre-tighten the screws crosswise firstly.
CAUTION
Do not mix the flange screws used for CRB 15000-
5/0.95 and the threaded screws used for CRB
15000-10/1.52 and CRB 15000-12/1.27. Always
use washers together with the threaded screws
for CRB 15000-10/1.52 and CRB 15000-12/1.27.
Illustration is for reference only.
6
Valid for CRB 15000-12/1.27
xx2000001987
Valid for CRB 15000-10/1.52
xx2300000819
Tightening torque: 8.2 NmTorque tighten all screws crosswise.7
Removing the base from foundation (-10/1.52 and -12/1.27)
NoteAction
CAUTION
The weight of the swing and base together is
xxx
1
WARNING
Personnel must not, under any circumstances,
be present under the suspended load.
2
xxx
Loosen the robot base from the foundation by
removing the foundation attachment screws.
3
Continues on next page
756 Product manual - CRB 15000
3HAC077389-001 Revision: L
© Copyright 2021 - 2023 ABB. All rights reserved.
5 Repair
5.5.2 Replacing the swing
Continued
To Next Page
Loading...
