ABB ETL600 - Page 322

Revision: Language: Page:
ETL600 System Test Report
_ EN B10/B11
HE
Test
No. Test procedure Test point
Permissible
value Units
Test
result
N11 N22 N34 N54 N65
B.10.14 Teleoperation AF4
Mark if configured:
[ ] [ ] [ ] [ ] [ ]
Fed input level, [dBm],
@ 800 Hz at AF4-IN of
remote.
Expected Output
level at AF4-OUT
Measured Output level
at AF4-OUT
N11: ___________
N22: ___________
N34: ___________
N54: ___________
N65: ___________
Feed into rem. equ. at
terminal,
teleop. 7a-7b
Measure at terminal,
teleop. 8a-8b
ext. Boost not active.
N11: _______±1
N22: _______±1
N34: _______±1
N54: _______±1
N65: _______±1
dBm
(600 Ω)
N11: ___________
N22: ___________
N34: ___________
N54: ___________
N65: ___________
N11 N22 N54
B.10.15 Teleoperation AF4
used for ext.
teleprotection
Mark if configured:
[ ]
[ ] [ ]
Test EXT-BOOST:
A
ctivate at remote equ.
at terminal, teleop.
9a-9b.
Fed input level, [dBm],
@ 800 Hz at AF4-IN
Feed into rem. equ. at
terminal, teleop.7a-7b
Expected Output
level at AF4-OUT
Measured Output level
at AF4-OUT
N11: ___________
N22: ___________
N54: ___________
Measure at terminal,
teleop. 8a-8b
N11: _______±1
N22: _______±1
N54: _______±1
dBm
(600 Ω)
N11: ___________
N22: ___________
N54: ___________
B.11 Testing of V.11 ports
B.11.1 V.11 Port 1
Front plate P4LT/P4LU
BER test
V.11 PORT 1
No bit errors
during ____ sec
[ ]
B.11.2 V.11 Port 2
Front plate P4LT/P4LU
BER test
V.11 PORT 2
No bit errors
during ____ sec
[ ]
B.12 Testing of V.24 ports
B.12.1 V.24 Port 1
Front plate P4LT/P4LU
BER test
V.24 PORT 1
No bit errors
during ____ sec
[ ]
B.12.2 V.24 Port 2
Front plate P4LT/P4LU
BER test
V.24 PORT 2
No bit errors
during ____ sec
[ ]
B.12.3 V.24 Port 3
Front plate P4LT/P4LU
BER test
V.24 PORT 3
No bit errors
during ____ sec
[ ]
B.12.4 V.24 Port 4
Front plate P4LT/P4LU
BER test
V.24 PORT 4
No bit errors
during ____ sec
[ ]
B.12.5 V.24 Port 5
Front plate P4LT/P4LU
BER test
V.24 PORT 5
No bit errors
during ____ sec
[ ]
© ABB Switzerland Ltd Form 1KHW001493-EN
Rev. A