ABB Fimer PVI-10.0/12.5-TL-OUTD - Connections to the Communication and Control Board

58
000440BG-F
5 - Installation
Connections to the communication and control board
Each cable which must be connected to the communication and control
board must pass through one of the three service cable glands M20
12
, which take a cable with a diameter of 7 mm to 13 mm. Gaskets with
two holes are supplied as standard to insert into the cable gland, which
enables two separate cables of a maximum cross-section of 5 mm to be
accommodated.
12
A B C