ABB Foundation LD 810HSE Ex - Table of Contents

4 Quick Installation Guide LD 810HSE Ex | 2PAA118721
Section 1 Introduction ........................................................................................... 5
Intended use ......................................................................................................... 6
Section 2 Installation ............................................................................................. 7
Installation in Hazardous Locations ........................................................................ 7
General Requirements ........................................................................................... 8
Hazardous Location - North American Approval (cULus) ...................................... 11
Hazardous Location - European and International Approval (ATEX, IECEx) ........... 12
Mounting and Dismounting .................................................................................. 13
Connection Diagram ............................................................................................ 15
Connecting the Power Supply ............................................................................. 16
Ethernet Ports ..................................................................................................... 17
Redundancy Link Interface .................................................................................. 18
FF-H1 Interfaces ................................................................................................. 20
Conguring LD 810HSE Ex .................................................................................. 22
Section 3 Status Indicators - LEDs ..................................................................... 23
LED Indicators in Stand-Alone Mode (RUN and ERR) ........................................... 24
LED Indicators in Redundant Mode (RUN, ERR, and RDL) ................................... 25
Status Indications of the 4 H1 Channels .............................................................. 29
Section 4 Specications ...................................................................................... 30
Section 5 Manufacturer‘s Declaration ................................................................. 33
Table of Contents