ABB FOX61 Series - AP:; Unit-X; Port-Y, Configuration - Synchronization; Table 11: AP:; Unit-X; Port-Y, Configuration - Synchronization

FOXCST REFERENCE
FOX61xLEDE1 37
Risk of operating trouble!
Changing the P12 termination mode results in most cases in incompatible
layer rates or number of timeslots.
→ The channel with its CTP and the assigned connections are deleted
automatically and must be newly created.
→ Please refer to "1KHW002467 FOX61x TDM Services", section 4.2.2.
8.3.3.2 AP: / unit-x / port-y, Configuration - Synchronization
Table 11: AP: / unit-x / port-y, Configuration - Synchronization
Operation Name Parameter Name Range Description / Details
Synchronization Method None Do not use a synchronization method
SSM-Sa4 Use the selected Sa bit in time slot 0 for the
transport of the synchronization status message
(SSM).
These parameter values are only available with
the termination modes “PCM30C” and
“PCM31C”.
SSM-Sa5
SSM-Sa6
SSM-Sa7
SSM-Sa8
SSI-Sa5 Use the Sa5 bit in time slot 0 for the transport of
the synchronization status indication (SSI).
The SSI method is ABB proprietary and is com-
patible with the FOX51x.
This parameter value is only available with the
termination modes “PCM30”, “PCM30C”,
“PCM31” and “PCM31C”.
QL Transmission Source ESI-1 Synchronization sources are all the PDH clock
sources as they are configured at the AP: /ne,
Configuration - PETS
ESI-2
<PDH Clock Source 1>
<PDH Clock Source 2>
<PDH Clock Source 3>
<PDH Clock Source 4>
Internal
Usage NA No synchronization method has been selected.
CanBeUsed Transmit the QL value of the selected synchroni-
zation source
DoNotUse Transmit the QL value 15, i.e. indicating that the
traffic signal cannot be used as a synchroniza-
tion source.