GBMounting
• Switch off the 230-V mains supply!
• In the event the connecting leads have to be exten-
ded:
– Run these leads (max. 2.5 mm
2
conductor cross
section) into the interior of the mounting enclosure
to be used (eg. flush-mounted double box).
– Connect these leads to the screwless box
terminals provided for this purpose.
• Hook up the connecting lines of the unit as shown
in the wiring diagram (Fig. 2).
• Unless done earlier, assign the physical address
(see Commissioning).
• Complete mounting work:
The 230-V mains supply must be disconnected!
A special fastening arrangement or mounting
position of the unit is not required.
Place the unit into the mounting box and close off
boxe(s).
To Next Page
Loading...
