GBCommissioning
The relevant application versions available with
pertinent parameters can be seen from the current
Technical Manual of the ABB i-bus
®
EIB.
• Connect a PC with EIBA Tool Software (ETS2 V1.1) to
the EIB via an RS232 interface.
• Switch on the power supply to the EIB bus line.
• Assign a physical address.
Do not use pointed or sharp-edged objects when
pressing the programming key because this might
damage the flexible cover over the key opening!
– Press the programming key;
the red programming LED will become illuminated.
– After the physical address has been programmed,
the red LED will go out.
– Write the number of the physical address on
your device using a smudge-proof pencil.
• Select and parameterize the application.
• Assign the group address(es).
• Cut in the 230-V power supply.
To Previous Page
Loading...
