GB
If the physical address has not yet been assigned,
the programming key (Fig. 2) should remain
accessible.
Do not cut in the required 230-V power supply before
all connections have been properly hooked up and
insulated!
The unit can be mounted in a cable duct with two
combined wall and joint boxes (due to separation of
low voltage and 230-V system).
For flush-mounted installation two deep double boxes
or one electronic box (eg. Kaiser make) can be used.
With both installation methods the connecting leads
for the positioner (servo-drive) are run out of the box
via central disk 2527-xx or 1749-xx.
Connection must
only be effected via
push-lock
(screwless) box terminals
.
To adhere to the safety class specified under
„Technical Data“ the connecting terminals have to
be placed inside the mounting boxes.
Mounting Instructions
To Next Page
Loading...
