ABB IMASI23 - Page 130

Index (continued)
WBPEEUI240774A0 Index - 3
O
Offset and gain adjustment............................. 2-8
Onboard indicators ...........................2-4, 5-1, 6-1
Online configuration......................................2-11
Open input detection .............................1-3, 2-10
Operating modes ............................................6-6
Operating procedures..............................5-1, 6-1
Operation........................................................5-1
P
P1, P2, P3 connectors....................................3-6
PCB cleaning..................................................7-3
Point value calculation....................................2-7
Power, logic ..................................................2-11
Preventive maintenance
Checking connections..................................7-4
Schedule...................................................... 7-1
Tools and equipment ................................... 7-2
Processing I/O inputs .....................................2-6
R
Reference documents .................................... 1-5
Repair and replacement .................................8-1
Restoring factory calibration ........................... 4-4
RTD types....................................................... 1-2
S
S1 address switch
Settings........................................................ 3-3
Settings and error codes.............................. 6-6
Security and integrity checks
Alarm and exception reporting...................2-11
Diagnostics during normal operation ......... 2-10
Diagnostics in diagnostic mode ...................2-9
Diagnostics on reset .................................. 2-10
I/O expander bus .......................................2-10
Open input detection..................................2-10
Select address ................................................3-3
Setup and installation
Address switch (S1) .....................................3-3
Binary address .............................................3-3
Configuring inputs ........................................3-4
Jumper configuration ...................................3-4
Jumper location............................................3-4
Jumpers used for each channel...................3-4
Physical installation......................................3-5
Termination unit configuration......................3-5
Special handling..............................................3-1
Specifications..................................................1-6
Startup ............................................................5-1
Switch settings................................................2-3
T
Termination.....................................................2-5
Cable connections .......................................3-7
Unit...............................................................3-5
Test equipment required.................................6-5
Thermocouples ................................ 1-2, 1-3, 2-7
Troubleshooting ..............................................6-1
Onboard indicators.......................................2-4
S1 settings and error codes .........................6-6
U
Unpacking and inspection...............................3-2
User gain and offset........................................2-8
W
Wiring connections and cabling ......................3-7
Cable connections .......................................3-7
Description ...................................................3-6
P1, P2, P3....................................................3-6