6.Installation
Warranty
Safe operation is ensured if assembly work has been carried out according to these user instructions.
Furthermore, the instructions in the manual must be observed.
Authorized Personnel
Assembly, connection, and removal work should only be carried out by authorized and qualified
personnel.
6.1.Control Unit
Assembly on 35mm DIN-Rail
To assemble the control unit, perform steps 1 and 2. The device can be mounted horizontally or vertically.
To disconnect, perform steps 3, 4 and 5.
The SCU100 can be mounted on all 35 mm DIN rails (DIN50022).
The device can be installed for single or three phase use.
For commissioning a connection via LAN has to be established.
4
1
2
3
5
SCU100 INSITE PRO M COMPACT USER MANUAL 21
To Next Page
Loading...
