ABB IRB 1200 - Page 172

NoteArticle numberSpare part
Includes brackets, sheets, dis-
tance screws, plastics, cable
clamp, seal bolts and air protec-
tion in tubular.
3HAC049663-001Cable harness material set
Includes tubular flange, air con-
nectors and seal bolts.
3HAC049664-001Air connector set with Ethernet
hole in flange
Replace if damaged.
Includes tubular flange, air con-
nectors and seal bolts.
3HAC049665-001Air connector set without Ether-
net hole in flange
Replace if damaged.
Used with protection type Hy-
gienic.
3HAC078810-001Plate without connector set
Includes gasket (3HAC078804-
001).
Used with protection type Hy-
gienic.
3HAC079691-001Plate with connector set
Includes Ethernet connector, air
connectors, CP/CS connector
and gasket (3HAC078804-001).
Used with protection type Hy-
gienic.
3HAC078804-001Gasket
Replace if damage.
Replace if damaged.3HAC049667-001Base bottom cover (standard
configuration)
Replace if damaged.3HAC059675-001Base rear cover, without connect-
or interface
Used with protection type Clean
Room.
3HAC056147-001Base rear cover, without connect-
or interface, Clean Room
Used for robots with food grade
lubrication.
Base rear cover, without connect-
or interface, food grade lubrica-
tion
Used with protection type Hy-
gienic.Base rear cover, without connect-
or interface, Hygienic
Replace if damaged.
Not used with protection class
IP40.
3HAC058566-001 /
3HAC080710-001
Gasket for rear base cover
Replace if damaged.
Not used with protection class
IP40.
3HAB3772-86O-ring
Replace if damaged.
Not used with protection class
IP40.
3HAB3701-47Radial sealing with dust lip
Replace if damaged.
Used with protection class IP67.3HAC044641-002M2 variseal sealing
Used only on base
3HAC049628-001. See Spare
part versions for the base on
IP40/IP67 robots on page 874.
Replace if damaged.
Replace if damaged.3HAC044676-001 /
3HAC068107-001
i
Axis-1 sealing ring
Continues on next page
172 Product manual - IRB 1200
3HAC046983-001 Revision: S
© Copyright 2014 - 2021 ABB. All rights reserved.
4 Repair
4.3.1 Replacing the main cable package
Continued