ABB IRB 1200 - Page 453

NoteAction
For robots with protection type Clean
Room
For robots with protection type Clean
Room
3
For robots with food grade lubricationFor robots with food grade lubrication
Sealant, SikaFlex 521FCFor robots with protection type Hygienic
For robots with protection type HygienicApply a string of the sealant to the joint of
the upper arm housing cover.
Sealant, Trans Clear
xx1600000215
Smooth out the sealant string using a finger
tip. Use washing-up on finger tips to get a
smooth joint.
If necessary, add extra sealant to get a full
cover joint.
For robots with protection type Clean
Room
4
For robots with food grade lubrication
For robots with protection type Hygienic
Clean, seal and paint the joints that have
been opened. See Cut the paint or surface
on the robot before replacing parts on
page 158.
Note
After all repair work, wipe the robot free
from particles with spirit on a lint free cloth.
Calibration information is included in sec-
tion Calibration on page 805.
Recalibrate the robot.5
DANGER
Make sure all safety requirements are met
when performing the first test run.
6
Product manual - IRB 1200 453
3HAC046983-001 Revision: S
© Copyright 2014 - 2021 ABB. All rights reserved.
4 Repair
4.4.4 Replacing the axis-3 radial sealing and sealing ring
Continued