ABB IRB 14000 - Page 216

Removing the wave generator from the motor
NoteAction
Remove the wave generator from the motor shaft
by removing the set screw(s) and then pulling it
off the shaft.
1
xx1500000515
Axis 1, axis 2, axis 7, axis 3.
xx1500001651
Axis 4, axis 5 and axis 6.
Place the wave generator on a clean workbench,
if not instantly fitting it to a new motor.
CAUTION
Keep the wave generator clean.
2
Continues on next page
216 Product manual - IRB 14000
3HAC052983-001 Revision: D
© Copyright 2015 - 2016 ABB. All rights reserved.
4 Repair
4.4.7 Replacing the axis-6 motor
Continued