ABB IRB 14000 - Refitting the Power Supply

NoteAction
Disconnect the cables, cut cable ties if necessary:
• G1.SK2
• G1.(-)
• G1.(+)
• G1.N
• G1.L
• GND
4
xx1500000287
Remove the attachment screws that fastens the
power supply.
5
Refitting the power supply
Use this procedure to refit the power supply.
Refitting the power supply
NoteAction
Power supply: 3HAC047966-001Place the new power supply on the bottom cover
and tighten the attachment screws.
1
Screws: M4x6 8.8-A2F (7 pcs).
Tightening torque:
xx1500000287
Connect the cables on the side of the power sup-
ply.
• G1.SK2
• G1.(-)
• G1.(+)
• G1.N
• G1.L
• GND
2
Fasten the cables with cable ties.3
Continues on next page
Product manual - IRB 14000 323
3HAC052983-001 Revision: D
© Copyright 2015 - 2016 ABB. All rights reserved.
4 Repair
4.7.4 Replacing the power supply
Continued