ABB IRB 14000 - Page 328

NoteAction
xx1500000308
Loosen the left attachment screw and remove the
right attachment screw.
4
Slide the power distribution board to the right.5
Lift the power distribution board out.6
Refitting the power distribution board
Use this procedure to refit the power distribution board.
Refitting the power distribution board
NoteAction
DSQC 662 Power distribution
board: 3HAC026254-001
Place the power distribution board and slide it to
the left.
1
Screws: M3x6 (2 pcs).Tighten the left attachment screw and refit the
right attachment screw.
2
Tightening torque: 0.9 Nm.
xx1500000308
Connect the connectors:
• G2.X8 (X8)
• G2.XS2 (X2)
• G2.XS1 (X1)
• G2.XS3 (X3)
• G2.XS6 (X6)
• G2.XS5 (X5)
• G2.XS7 (X7)
• G2.XS4 (X4)
3
Put two cable ties around the plate and the G2.X8
connector.
4
Continues on next page
328 Product manual - IRB 14000
3HAC052983-001 Revision: D
© Copyright 2015 - 2016 ABB. All rights reserved.
4 Repair
4.7.5 Replacing the power distribution board
Continued