Refitting the fieldbus adapter
Use this procedure to refit the fieldbus adapter.
Refitting the fieldbus adapter
NoteAction
DANGER
Make sure that all supplies for electrical power
and air pressure are turned off.
1
ELECTROSTATIC DISCHARGE (ESD)
The unit is sensitive to ESD. Before handling the
unit please read the safety information in the
section WARNING - The unit is sensitive to ESD!
on page 55
2
Fit the fieldbus adapter by pushing it along the
rails on the motherboard.
CAUTION
Always grip the fieldbus adapter around the edges
to avoid damage to the adapter or its components.
3
CAUTION
Make sure that the adapter is pushed straight onto
the rails.
Push carefully so no pins are damaged.
xx0700000193
Attachment screw (2 pcs)A
Fastening mechanismB
Fasten the fieldbus adapter with its attachment
screws.
4
Continues on next page
Product manual - IRB 14000 407
3HAC052983-001 Revision: D
© Copyright 2015 - 2016 ABB. All rights reserved.
4 Repair
4.7.16 Replacing the fieldbus adapter
Continued
To Next Page
Loading...
