ABB IRB 4600 Foundry Prime - Measuring the Play, Axis 5

4.4.4 Measuring the play, axis 5
General
After reassembly due to repair work or any other reason, the play in axis 5 and 6
must be checked to ensure the repetition accuracy of the robot positioning. The
procedure for axis 5 is detailed below.
Required equipment
NoteArticle numberEquipment, etc.
Content is defined in sec-
tion Standard tools on
page 393.
-Standard toolkit
3HAB1611-6
Measuring tool, play
(IRB 4600 -60/2.05
These procedures include
references to the tools re-
quired.
Other tools and procedures may be required.
See references to these procedures in the
step-by-step instructions below.
Additional equipment - Foundry Prime
NoteArticle numberEquipment
Mercasol3HAC034903-001Rust preventive
3HAC026759-001Sikaflex 521FC
12340011-116Loctite 574
Brush
3HAC035355-001Foundry Prime touch up kit
Measurement, axis 5
The procedure below details how to measure the play of axis 5.
Note
The measuring tool and measuring values differ depending on robot version.
InformationAction
DANGER
Turn off all:
• electric power supply
• hydraulic pressure supply
to the robot, before entering the robot
working area.
1
Move the robot to calibration position and
turn the axis 4 90°.
2
Article number is specified in Required
equipment on page 290.
Fit the measuring tool, play to the turning
disc.
3
Continues on next page
290 Product manual - IRB 4600 Foundry Prime
3HAC040585-001 Revision: M
© Copyright 2013-2018 ABB. All rights reserved.
4 Repair
4.4.4 Measuring the play, axis 5