NoteAction
xx0800000441
Note
Check, when fitting the lifting lug, that both
oil plugs will be placed in the correct posi-
tion after the gearbox is fitted as shown in
the figure. The oil plugs shall be placed in
the openings in the frame.
5
A Opening for oil plug in frame
B Oil plug
See the figure in:
• Location of gearbox on page 326
Replace o-ring if damaged.
Apply grease on the o-ring.6
Clean all assembly surfaces.7
Remove any painting from the assembly
surfaces, with a knife.
xx1800000793
Fit two guide pins to the frame.8
Guide pin, M8x150: 3HAC15520-2
Always use guide pins in pairs!
Guide for reduction gear: 3HACxxx.
xx1800000795
Fit the guide for the gear on top of the pro-
tection tube.
It protects the radial sealing from being
damaged during refitting.
9
Continues on next page
Product manual - IRB 4600 Foundry Prime 333
3HAC040585-001 Revision: M
© Copyright 2013-2018 ABB. All rights reserved.
4 Repair
4.8.1 Replacing gearbox axis 1
Continued
To Next Page
Loading...
