4 Repair
4.6.1. Replacement of motor, axis 1
3HAC026876-001 Revision: C304
© Copyright 2006-2008 ABB. All rights reserved.
2. Remove the cover for connector access on top of
the motor by unscrewing its four attachment
screws.
xx0600002874
• A: Attachment screw
•B: Air hose
• C: Top cover
• D: Motor unit
3.
NOTE!
Keep the old top cover, with the air nipple
mounted.
4. Remove the motor unit, according to step 5 and
forwards in section Removal, motor axis 1 on
page 301.
5. Fill the four screw recesses on the new motor with
Sikaflex. (After hardening, Sikaflex can be formed
with a knife)
xx0600002875
•A: Motor unit
• B: Sikaflex in screw
recesses
6. Continue to refit the new motor according to
section, Refitting, motor axis 1 on page 302.
Action Note
A
C
Continued
Continues on next page
To Next Page
Loading...
