Preparation of the frame before refitting of gearbox axis 2
Use this procedure to make the necessary preparations of the frame before refitting
gearbox axis 2.
NoteAction
xx1000000379
Clean the machined surface in the frame as
shown in the figure, from paint, oil, corro-
sion coating or other kinds of contamination.
1
Parts:
• A: Joint surface
• B: Surface for o-ring
• C: Machined surface
See figure above.Clean the joint surface carefully, by remov-
ing old corrosion coating and/or flange
sealing from the surface.
2
See figure aboveClean the surface for the o-ring.3
See figure aboveApply Mercasol on the machined surface.
Note
Make sure there is no Mercasol on the joint
surface!
4
Continues on next page
412 Product manual - IRB 6640 Foundry Prime
3HAC040586-001 Revision: N
© Copyright 2011-2018 ABB. All rights reserved.
4 Repair
4.7.2 Replacing gearbox axis 2
Continued
To Next Page
Loading...
