3 Maintenance
3.3.6. Inspection, oil level gearbox axis 6
1513HAC023082-001 Revision: E
© Copyright 2004-2008 ABB. All rights reserved.
Analysis of water content in oil, gearbox axis 6 (Foundry Prime)
When changing oil, check for water content in oil an analysis can be ordered from the oil
manufacturer Shell.
5. Add oil if required. Art. no. is specified in Required
equipment on page 150!
Further information about how to fill
the oil may be found in section Filling,
oil, axis 6 on page 199.
6. Refit the oil plug, filling. Tightening torque: 24 Nm.
7.
WARNING!
Do not mix the oil types! If wrong oil is refilled,
the gearbox must be rinsed as detailed in
section WARNING - Mixed oils may cause
severe damage to gearbox! on page 42!
Action Note
If: Then....
1. More than 2% water in oil,
• With more than 2% water content
there is a risk for corrosion in the
gearbox and reduced viscosity in
the oil.
replacement of gearbox axis 6 is required
every second year
xx0600003155
• A: Water content in oil from gearbox
axis 6
• B: Months or hours in operation
• C: Replacement of gearbox axis 6
2%
6
12
18
24
30
3000 6000 9000
12000
15000
A
B
C
Continued
Continues on next page
To Next Page
Loading...
