3 Maintenance
3.4.4. Oil change, gearbox, axis 3
1893HAC023082-001 Revision: E
© Copyright 2004-2008 ABB. All rights reserved.
Draining, oil
The procedure below details how to drain oil from the gearbox, axis 3.
When using the oil exchange equipment, follow the instructions enclosed with the kit. Art.
no. for the kit is specified in Required equipment on page 188.
Standard toolkit - The contents are defined in
section Standard toolkit on page
436.
Equipment, etc. Art. no. Amount Note
Action Note
1.
DANGER!
Turn off all electric power, hydraulic and
pneumatic pressure supplies to the robot!
For Foundry Prime robots: Do not turn off the
air pressure to motors and SMB.
2.
WARNING!
Handling gearbox oil involves several safety
risks. Before proceeding, please observe the
safety information in section WARNING -
Safety risks during work with gearbox oil on
page 41.
3. Remove the oil plug, draining, and drain the
gearbox oil using a hose with nipple and an
oil collecting vessel.
Remove the oil plug, filling in order to drain
the oil quicker!
Shown in the figure Location of gearbox
on page 188!
Vessel capacity is specified in Required
equipment on page 188!
Draining is time-consuming. Elapsed
time varies depending on the
temperature of the oil.
4. Refit the oil plug. Tightening torque: 24 Nm.
Continued
Continues on next page
To Next Page
Loading...
