Description
Product Specification IRB 6600 M2000 39
Description of Water and Air unit
The Water and Air unit contains components for water and air distribution and control
within the SpotPack. The water and air unit is via the process software controlled from
the robot controller. Wiring is made via the power unit.
The capacity and functionality depends on the choice of different option combinations,
see option description.
The unit is mounted at the manipulator base. Control cables to the unit has quick
connectors in both ends and has the same cable length as the one specified for the robot
control cable. The unit is only used for the spot welding applications.
* Max air pressure 16 bar / 230 PSI, max water pressure 10 bar / 145 PSI. (Parker
Pushlock reference 3C382-15-8BK, brass version)
** Plugged at delivery (to be used for tip-dresser or other equipment). (Fitting 1/2"
BSP 1,5).
Signals for water and air unit:
Electrical connections to robot I/O board are made via the splitbox on the water and air
unit. Total 6 x M12 connections (4 pins) are available. The number in use depends on
option choices but minimum 2 are in use within the SpotPack. Free connections can be
used for customer purpose like tip-dresser control (Max 0,5 amp, 24 DC Volt).
Table 4
Type Pcs Specification
Connections for media
Incoming water
Outgoing water
Incoming air
Extra air outlet
1
1
1
1
Parker PushLock fitting, M22 (conical angle 24°)*
Parker PushLock fitting, M22 (conical angle 24°)*
Parker PushLock fitting, M22 (conical angle 24°)*
1/2" connection. **
To Next Page
Loading...
