Description
Product Specification S4Cplus M2000/BaseWare OS 4.0 5
1.2 Safety/Standards
The robot conforms to the following standards:
EN 292-1 Safety of machinery, terminology
EN 292-2 Safety of machinery, technical specifications
EN 954-1 Safety of machinery, safety related parts of control
systems
EN 60204 Electrical equipment of industrial machines
IEC 204-1 Electrical equipment of industrial machines
ISO 10218, EN 775 Manipulating industrial robots, safety
ANSI/RIA 15.06/1999 Industrial robots, safety requirements
ISO 9787 Manipulating industrial robots, coordinate systems
and motions
IEC 529 Degrees of protection provided by enclosures
EN 50081-2 EMC, Generic emission
EN 61000-6-2 EMC, Generic immunity
ANSI/UL 1740-1996 (option) Standard for Industrial Robots and Robotic
Equipment
CAN/CSA Z 434-94 (option) Industrial Robots and Robot Systems - General
Safety Requirements
The robot complies fully with the health and safety standards specified in the EEC’s
Machinery Directives.
The robot controller is designed with absolute safety in mind. It has a dedicated safety
system based on a two-channel circuit which is monitored continuously. If any
component fails, the electrical power supplied to the motors shuts off and the brakes engage.
Safety category 3
Malfunction of a single component, such as a sticking relay, will be detected at the next
MOTOR OFF/MOTOR ON operation. MOTOR ON is then prevented and the faulty
section is indicated. This complies with category 3 of EN 954-1, Safety of machinery
- safety related parts of control systems - Part 1.
Selecting the operating mode
The robot can be operated either manually or automatically. In manual mode, the robot
can only be operated via the teach pendant, i.e. not by any external equipment.
Reduced speed
In manual mode, the speed is limited to a maximum of 250 mm/s (600 inch/min.).
The speed limitation applies not only to the TCP (Tool Centre point), but to all parts of
the robot. It is also possible to monitor the speed of equipment mounted on the robot.
Three position enabling device
The enabling device on the teach pendant must be used to move the robot when in
manual mode. The enabling device consists of a switch with three positions, meaning
that all robot movements stop when either the enabling device is pushed fully in, or
when it is released completely. This makes the robot safer to operate.
To Next Page
Loading...
