3 Maintenance
3.3.14. Inspection, signal lamp
3HAC020993-001 Revision: G150
© Copyright 2004-2008 ABB. All rights reserved.
3.3.14. Inspection, signal lamp
Location of signal lamp
The signal lamp is located as shown in the figure below. Note that the position can differ
depending on how the customer harness for axis 4-6 is mounted. See assembly drawing on
the current harness for alternative positioning.
xx0200000240
Required equipment
A Signal lamp
B Clamp
C Position for cable gland
D Warning label on motor cover
E Warning sign on motor cover
Equipment, etc. Art. no. Note
Signal lamp 3HAC 10830-1 To be replaced in case of detected
damage.
Standard toolkit - The contents are defined in section
Standard toolkit on page 388.
Other tools and procedures may
be required. See references to
these procedures in the step-by-
step instructions below.
These procedures include
references to the tools required.
Continues on next page
To Next Page
Loading...
