3 Maintenance
3.7.4. Setting the SIS parameters
1953HAC020993-001 Revision: G
© Copyright 2004-2008 ABB. All rights reserved.
3. Select "0 SIS parameters"
and press "Enter".
en0200000047
xx0100000200
4. Select the required system
The parameter list is
displayed.
en0200000048
en0200000049
5. Select the required
parameters by stepping up
and down through the
parameter list.
Available parameters are described in section Defining the
SIS input parametersSIS system parameters on page 192.
Action Note
Continued
To Next Page
Loading...
