4 Repair
4.5.4. Replacement of balancing device
3HAC020993-001 Revision: G288
© Copyright 2004-2008 ABB. All rights reserved.
Locking screw 3HAA1001-266 M16 x 60
For securing the lower arm.
Securing screw 9ADA 183-66 M12 x 35, 2 pcs required
For securing the bearing
attachments to the
balancing device when
lifting.
Bearing grease 3HAB 3537-1 For lubricating the o-rings
and the shaft.
Grease 3HAA 1001-294 80 ml, Optimol PDO
For lubrication of spherical
roller bearing in ear, in case
of new balancing device.
Rust preventive 3HAC026621-001 Equivalent:
• Mercasol 3106
Locking liquid - Loctite 243
To apply to the securing
screw in the shaft.
Grease pump - To lubricate spherical roller
bearing.
Guide pins M16 x 300 3HAC13120-5 Always use guide pins in
pairs!
Lifting eye M12 3HAC14457-3
Shackle, balancing
device
3HAC 020997-1
Lifting tool (chain) 3HAC15556-1
Press tool, balancing
device
3HAC020902-001
Puller tool, balancing
device shaft
3HAC12475-1
Press tool, balancing
device shaft
3HAC17129-1
Hydraulic cylinder 3HAC11731-1 To be used with the press
and puller tools.
2 pcs required!
Hydraulic pump, 80
MPa
3HAC13086-1 To be used with the
hydraulic cylinder.
Hydraulic valve with
hose
3HAC022643-001
Standard toolkit - The contents are defined in
section Standard toolkit on
page 388 in part 2 of the
Product manual.
Other tools and
procedures may be
required. See
references to these
procedures in the
step-by-step instruc-
tions below.
These procedures include
references to the tools
required.
Equipment Spare part no. Art. no. Note
Continued
Continues on next page
To Next Page
Loading...
