4 Repair
4.5.5. Unloading the balancing device
3HAC020993-001 Revision: G296
© Copyright 2004-2008 ABB. All rights reserved.
Required equipment
Using the correct press device
The different designs of the balancing device require different versions of the press device,
included in the complete press tool. The table below specifies which press device to use to
which balancing device.
The article number of the balancing device may be found on a label at the rear of the balancing
device.
Unloading the balancing device
The procedure below details how to use the press tool in order to unload the balancing device.
How to remove the press tool, is detailed in section Restoring the balancing device on page
298.
Equipment, etc. Art. no. Note
Press tool, balancing device 3HAC020902-001 Includes
• press device 3HAC 15767-2
• press device 3HAC 18100-1
Choose the correct device, depending
on model of balancing device.
Hydraulic cylinder 3HAC11731-1 To be used with the press tool.
2 pcs required!
Hydraulic valve with hose 3HAC022643-001
Hydraulic pump, 80 MPa 3HAC13086-1 To be used with the hydraulic cylinder.
Standard toolkit 3HAC 15571-1 The contents are defined in section
Standard toolkit on page 388 in part 2
of the Product manual.
Balancing device Press device
Art. no: 3HAC 021204-001
xx0300000598
Art. no: 3HAC 15767-2
xx0300000600
Action Note/Illustration
1. Fit the moving pin to the current press device. Choose the correct press device,
according to the table Using the correct
press device on page 296.
The moving pin is shown in the figure
Press tool and hydraulic cylinder on
page 295.
Continued
Continues on next page
To Next Page
Loading...
