4 Repair
4.6.4. Replacement of motor, axis 4
3213HAC020993-001 Revision: G
© Copyright 2004-2008 ABB. All rights reserved.
Required equipment
Equipment, etc. Spare part no. Art. no. Note
Motor including
pinion
3HAC15889-2 Includes
• motor
•pinion
• o-ring 2152 2012-430
O-ring 2152 2012-430 Must be replaced when reas-
sembling motor!
Sikaflex251FC 3HAC026620-001 Option Foundry Prime
Gasket 3HAC3438-1 Option Foundry Prime
Lifting tool, motor ax
1, 4, 5
3HAC 14459-1
Removal tool, motor
M10x
Lifting tool, motor ax
2, 3, 4
3HAC 14459-1
Lifting tool, motor ax
1, 4, 5
Lifting tool, motor ax
2, 3, 4
Grease 3HAC 3537-1 Used to lubricate the o-ring.
Removal tool. motor
M10x
3HAC 14972-1 Always use the removal tools
in pairs!
Guide pins M8 x 100 3HAC 15520-1 For guiding the motor.
Guide pins M8 x 150 3HAC 15520-2 For guiding the motor.
Rotation tool 3HAC 17105-1 Used to rotate the motor
pinion when mating it to the
gear, when brakes are
released with 24 VDC power
supply.
Power supply - 24 VDC, max. 1,5 A
For releasing the brakes.
Standard toolkit - The contents are defined in
section Standard toolkit on
page 388 in part 2 of the
Product manual.
Calibration
Pendulum toolkit
3HAC15716-1 Complete kit that also
includes operating manual.
Other tools and
procedures may be
required. See
references to these
procedures in the
step-by-step
instructions below.
These procedures include
references to the tools
required.
Circuit Diagram See chapter Circuit diagram
in the Product manual,
reference information.
Continued
Continues on next page
To Next Page
Loading...
