4 Repair
4.7.2. Replacement of gearbox axis 2
3HAC020993-001 Revision: G350
© Copyright 2004-2008 ABB. All rights reserved.
4. Fit the guide pins, sealing axis 2/3 to the rear
of the gearbox, axis 2.
Use the attachment holes shown in the figure
to the right!
xx0300000552
• A: Rear attachment screws,
gearbox (18 pcs)
• B: Holes for the guide pins,
sealing axis 2/3 on the gearbox
5. Fit the new sealing, axis 2/3 on to the guide
pins on the gearbox.
Note! Do not remove the guide pins for the
sealing until the rear attachment screws are
secured.
Art. no. is specified in Required
equipment on page 346!
6. Fit two guide pins, M12 in 180° relation to each
other in the frame, in the screw holes for the
gearboxes front attachment screws.
Art. no. is specified in Required
equipment on page 346!
xx0300000554
• A: Attachments in the frame for
the two guiding pins
7.
CAUTION!
The gearbox weighs 100 kg! All lifting
equipment used must be sized accordingly!
Action Note/Illustration
Continued
Continues on next page
To Next Page
Loading...
