2 Installation and commissioning
2.3.10. Installation of cooling fan for motors, axes 1-3 (option)
793HAC020993-001 Revision: G
© Copyright 2004-2008 ABB. All rights reserved.
Cooling fan
The details of the cooling fan are shown in the figure below.
xx0500002158
Required equipment
A Fanbox
B Attachment screws, fanbox plates (9 pcs)
C Groove in the connector
D Tightening screws, fanbox (3 pcs)
Equipment Art. no. Note
Cooling fan 3HAC15374-1
Cabling, position switches
and cooling fans, axes 1, 2
and 3
3HAC16659-1 Choose this cabling if equipping the robot
with both position switches and cooling
fans or with cooling fans on axis 3.
Cabling, cooling fans, axes
1 or 2
3HAC023599-001 Choose this cabling if only equipping the
robot with cooling fans on axis 1 or 2 (not
on axis 3 and not with position switches).
Plate for customer
connections
3HAC025778-001 An additional connection plate must be
fitted to the robot base, if not already
installed. The plate is shown in the figure
Plate for customer connections, at base
on page 80.
Continued
Continues on next page
To Next Page
Loading...
