NoteAction
Hydraulic pump 80 MPa, 3HAC13086-1.Apply the press tool, hydraulic pump and
nut on the threaded bar. Do not press yet!
9
Hydraulic cylinder, 3HAC11731-1.
xx1700000406
The item numbers refer to markings on the
tools.
xx1300000838
Put a big screwdriver between the cradle
and balancing device and use it as a dis-
tance tool.
10
Use caution and press the shaft end in po-
sition.
11
Remove the press tool and the threaded
bar.
12
xx1700000343
Fit the retaining ring bore.13
Loctite 243, 3HAB7116-1Apply locking liquid on the attachment
screw.
14
Continues on next page
488 Product manual - IRB 6700
3HAC044266-001 Revision: N
© Copyright 2013 - 2018 ABB. All rights reserved.
4 Repair
4.6.3 Replacing the rear bearings on the balancing device
Continued
To Next Page
Loading...
