ABB IRB 6700 Series - Page 696

Refitting the front shaft of the balancing device
NoteAction
Turn the power to the robot on temporarily.1
Use caution and jog the robot to the calibration
position (if not already done).
2
DANGER
Turn off all:
• electric power supply
• hydraulic pressure supply
• air pressure supply
to the robot, before entering the robot working
area.
3
Lifting shackle: SA-10-8-NA1Apply the lifting accessory to the balancing device
(if not already done).
4
Lifting accessory (chain):
3HAC15556-1
Remove all residue of Loctite in the screw hole of
the shaft.
5
Wipe all contact surfaces inside the recess clean
from contamination.
6
xx1300000784
Align the balancing device link ear with the hole
in the lower arm.
Note
Verify that the link ear is correctly turned.
7
A
B
C
A
xx1400000368
A Front link ear
B Shaft
C Mercasol (red dotted lines)
Foundry Plus:
Apply Mercasol on the surfaces on the shaft and
front ear.
8
Continues on next page
696 Product manual - IRB 6700
3HAC044266-001 Revision: N
© Copyright 2013 - 2018 ABB. All rights reserved.
4 Repair
4.8.3 Replacing the axis-2 gearbox (IRB 6700 - 235/2.65, IRB 6700 - 205/2.80, IRB 6700 - 175/3.05, IRB
6700 - 150/3.20, IRB 6700 - 200/2.60, IRB 6700 - 155/2.85)
Continued