Attaching the axis-3 gearbox to frame, step 1
NoteAction
Merkasol
xx1500002349
Apply Merkasol, 40 mm from the parallel arm side,
on the contact surface.
1
Area where to apply Merkasol, 40
mm wide from the parallel arm
side.
Merkasol
xx1500002350
Apply Merkasol on the surface of the sealing ring.
Note
Make sure that the sealing ring is attached cor-
rectly on the gearbox.
2
xx1500002344
Orient the gearbox to match the hole patterns
before lifting the gearbox onto the guide pins.
If the hole pattern does not match, carefully turn
the small gear in the gearbox very slowly, in order
to find the hole pattern.
xx1500002345
3
Continues on next page
742 Product manual - IRB 8700
3HAC052853-001 Revision: F
© Copyright 2015-2018 ABB. All rights reserved.
4 Repair
4.8.4 Replacing the axis-3 gearbox
Continued
To Next Page
Loading...
