Refitting the motor flange
NoteAction
xx1500002347
Remove the three M16x130 screws and six-hole
washers, previously attached in a triangle.
1
Clean the contact surfaces on gearbox and motor
flange.
2
xx1500002353
Clean o-rings and o-ring groove on gearbox.3
Inspect the o-rings. Replace if damaged!4
GreaseApply some grease on the o-rings.5
Attach the smaller o-ring in the gearbox groove.6
Attach the larger o-ring on the motor flange.7
xx1500002354
Before lifting the motor flange onto the guide pins,
make sure the oil inspection glass is facing at six
o'clock. See figure.
8
xx1500002314
Lift the motor flange onto the guide pins.9
Continues on next page
Product manual - IRB 8700 745
3HAC052853-001 Revision: F
© Copyright 2015-2018 ABB. All rights reserved.
4 Repair
4.8.4 Replacing the axis-3 gearbox
Continued
To Next Page
Loading...
